# ----------------------------------------------------------------------------------------------------
# Configuration file for GCore
# More information can be found in the documentation
# ----------------------------------------------------------------------------------------------------

# Display a heart at the beginning

display(HEART, baseX, baseY + 2.0, baseZ, 1)

# Display hearts around, every tick, while increasing Y coordinate

set(cx, baseX)
set(cz, baseZ)
set(radius, 0.5)
set(y, baseY)

loop(angle, 0, 360, 20)               			# make a loop using variable angle from 0 to 360 with steps of 20
	set(x, cx + radius * cos(angle))  	 		# calculate x
	set(y, y + 0.07)                   			# calculate y
	set(z, cz + radius * sin(angle))   			# calculate z
	wait_ticks(1)				      			# wait one tick
	display(HEART, x, y, z, 1)            		# display

# Display a heart at the end

display(HEART, baseX, baseY + 2.0, baseZ, 1)

# Wait 2 seconds until restarting

wait_ticks(40)